STARTER (for 2WD) REMOVAL


  1. REMOVE COWL TOP VENTILATOR LOUVER


    1. A01GM4S

      for LHD:

      Remove the 6 clips and cowl top ventilator louver RH.

    2. A01GI9P

      for RHD:

      Remove the 6 clips and cowl top ventilator louver LH.

  2. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

    Click here

  5. REMOVE NO. 3 EXHAUST MANIFOLD HEAT INSULATOR


    1. A01GINW

      Remove the 3 bolts and No. 3 exhaust manifold heat insulator.

  6. REMOVE STARTER ASSEMBLY


    1. A01GJOO

      Remove the 2 bolts and disconnect the starter assembly.

    2. A01GIQK

      Open the terminal cap.

    3. Remove the 2 nuts and disconnect the starter wire.

    4. Disconnect the starter connector and remove the starter assembly.

  7. REMOVE FLYWHEEL HOUSING SIDE COVER

    A01GNZP