ECM REMOVAL


  1. REMOVE COWL TOP VENTILATOR LOUVER


    1. A01GM4S

      for LHD:

      Remove the 6 clips and cowl top ventilator louver RH.

    2. A01GI9P

      for RHD:

      Remove the 6 clips and cowl top ventilator louver LH.

  2. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY


    1. A01GLYAE01

      Remove the 5 clips labeled A.

    2. Lift up the air cleaner inlet cover sub-assembly to detach the 4 clips labeled B, and remove the air cleaner inlet cover sub-assembly.

  5. REMOVE ENGINE ROOM SIDE COVER LH


    1. A01GK7CE01
      Text in Illustration
      *A for LHD
      *B for RHD

      Remove the 5 clips and engine room side cover LH.

  6. REMOVE ENGINE ROOM ECU COVER

    A01GIBD

    Note


    • Wipe off any water on or around the engine room ECU cover.

    • Perform these procedures in a dry place away from rain, etc.

    • Do not allow water to enter the ECM through its connectors areas, screw areas, etc.


    1. Remove the 3 bolts and engine room ECU cover.

  7. REMOVE TCM


    1. A01GLBN

      Disconnect the 4 TCM connectors.

    2. Remove the 2 nuts and TCM.

  8. DISCONNECT NO. 2 CONNECTOR HOLDER


    1. A01GKVFE03

      Disconnect the 2 engine wire connectors.

    2. Disconnect the 2 claws with the connector holder.

  9. REMOVE ECM


    1. A01GLAY

      Disconnect the 6 ECM connectors.

    2. Remove the 2 nuts and ECM.