ECM REMOVAL


  1. REMOVE COWL TOP VENTILATOR LOUVER RH

    A01GM4S

    1. Remove the 6 clips and cowl top ventilator louver RH.

  2. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE AIR CLEANER INLET COVER

    A01GNHGE01

    1. Remove the 5 clips labeled A.

    2. Lift up the air cleaner inlet cover sub-assembly to detach the 4 clips labeled B, and remove the air cleaner inlet cover sub-assembly.

  5. REMOVE ENGINE ROOM SIDE COVER LH


    1. A01GKBH

      Remove the 5 clips and engine room side cover LH.

  6. REMOVE ENGINE ROOM ECU COVER

    A01GIBD

    Note


    • Wipe off any water on or around the engine room ECU cover.

    • Perform these procedures in a dry place away from rain, etc.

    • Do not allow water to enter the ECM through its connectors areas, screw areas, etc.


    1. Remove the 3 bolts and engine room ECU cover.

  7. REMOVE TCM

    A01GLBN

    1. Disconnect the 4 TCM connectors.

    2. Remove the 2 nuts and TCM.

  8. REMOVE ECM

    A01GLAY

    1. Disconnect the 6 ECM connectors.

    2. Remove the 2 nuts and ECM.