CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION

INSTALL CENTER AIRBAG SENSOR ASSEMBLY

1. Check that the engine switch is off.

2. Check that the cable is disconnected from the negative (-) battery terminal.

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

3. 

   Text in Illustration

   *1	Waterproof Sheet

   Install the center airbag sensor assembly with the 3 bolts.

   Torque:

   18 N*m  { 184 kgf*cm, 13 ft.*lbf }

   Note

   
   

   • If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

   • When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

   • When the engine switch is first turned on (IG) after the center airbag sensor assembly has been replaced, make sure that no one is in the vehicle.

4. Connect the connector to the center airbag sensor assembly as shown in the illustration.

   Note

   When connecting airbag connector, take care not to damage the airbag wire harness.

5. Check that the waterproof sheet is properly set.

6. Check that there is no looseness in the installation parts of the center airbag sensor assembly.

INSTALL CONSOLE BOX ASSEMBLY

1. for 5-Passenger with Ottoman:

   Click here

2. w/o Rear Seat Entertainment System:

   Click here

3. w/ DVD Player:

   Click here

CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

CHECK SRS WARNING LIGHT

Click here