SPIRAL CABLE INSTALLATION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. INSTALL STEERING SENSOR


    1. A01GJJHE05
      Text in Illustration
      *1 Pin

      Align the 2 pins of the spiral cable sub-assembly with the locations shown in the illustration and attach the 6 claws to install the spiral cable sub-assembly to the steering sensor.

  2. INSTALL SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR

    Note


    • Do not replace the spiral cable sub-assembly with the battery connected and the engine switch on (IG).

    • Do not rotate the spiral cable sub-assembly with the battery connected and the engine switch on (IG).

    • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Check that the front wheels are facing straight ahead.

    4. Attach the 3 claws to install the spiral cable sub-assembly with sensor.

      Note

      When replacing the spiral cable sub-assembly with a new one, remove the lock pin before installing the steering wheel assembly.

    5. A01GM5B

      Connect the yellow airbag connector to the spiral cable sub-assembly with sensor.

    6. Connect the connectors to the spiral cable sub-assembly with sensor.

      Note

      When connecting airbag connector, take care not to damage the airbag wire harness.

  3. INSTALL STEERING COLUMN COVER


    1. w/o Driver Monitor Camera:

      Click here

    2. w/ Driver Monitor Camera:

      Click here

  4. PLACE FRONT WHEELS TO FACING STRAIGHT AHEAD

  5. ADJUST SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR

    Note

    Do not adjust the spiral cable sub-assembly with sensor with the battery connected and the engine switch on (IG).


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01GNO3

      Rotate the spiral cable sub-assembly counterclockwise slowly by hand until it stops.

      CAUTION:

      Do not turn the spiral cable sub-assembly using the airbag wire harness.

    4. A01GLREE01
      Text in Illustration
      *A w/o Steering Heater
      *B w/ Steering Heater
      *a Alignment Mark

      Rotate the spiral cable sub-assembly clockwise approximately 2.5 turns to align the marks.

      CAUTION:

      Do not turn the spiral cable sub-assembly using the airbag wire harness.

      Tech Tips

      The spiral cable sub-assembly will rotate approximately 2.5 turns to both the left and right from the center.

  6. INSTALL STEERING WHEEL ASSEMBLY

    Click here

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note


    • Make sure that the cable has been disconnected from the battery terminal for at least 2 seconds before reconnecting the cable.

    • Connect the cable to the negative (-) battery terminal with the front wheels facing straight ahead.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. ENABLE AUTOAWAY/RETURN FUNCTION


    1. Restore the autoaway/return function setting to the previous condition by changing the customize parameter Click here.

  9. INSPECT STEERING PAD


    1. Make sure that the horn sounds.

      Tech Tips

      If the horn does not sound, inspect the horn system Click here.

  10. CHECK SRS WARNING LIGHT

    Click here

  11. INSTALL COWL TOP VENTILATOR LOUVER RH


    1. A01GM4S

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      Be sure to install the cowl top ventilator louver RH properly. If it is not installed properly, water may enter the engine room and cause malfunctions.