ТОПЛИВНЫЙ НАСОС СНЯТИЕ


  1. DISCHARGE FUEL SYSTEM PRESSURE

    Click here

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FUEL TANK INSPECTION HOLE COVER


    1. Remove the 4 screws and fuel tank inspection hole cover.

  5. DISCONNECT NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY


    1. A01BF65E01

      Disconnect the No. 1 fuel evaporation tube sub-assembly from the fuel suction with pump and gauge tube assembly Click here.

  6. DISCONNECT FUEL TANK RETURN TUBE


    1. A01BASDE01
      Text in Illustration
      *1 Fuel Tube Joint
      *2 Fuel Tube
      *3 O-Ring
      *4 Tube Joint Clip

      Remove the tube joint clip and pull the fuel tank return tube out of the plug of the fuel suction with pump and gauge tube assembly.

      Note

      A01BAH7E18

      • Remove any dirt and foreign matter on the fuel tube joint before performing this step.

      • Do not allow any scratches or foreign matter on the parts when disconnecting them as the fuel tube joint contains the O-rings that seal the plug.

      • Perform this step by hand. Do not use any tools.

      • Do not forcibly bend or twist the nylon tube.

      • Protect the disconnected parts by covering them with plastic bags and tape after disconnecting the fuel tubes.

  7. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY


    1. A01BHC4E01
      Text in Illustration
      *1 Fuel Tube Joint
      *2 Fuel Tube
      *3 O-Ring
      *4 Tube Joint Clip

      Remove the tube joint clip and pull the fuel tank main tube sub-assembly out of the plug of the fuel suction with pump and gauge tube assembly.

      Note

      A01BAH7E18

      • Remove any dirt and foreign matter on the fuel tube joint before performing this step.

      • Do not allow any scratches or foreign matter on the parts when disconnecting them as the fuel tube joint contains the O-rings that seal the plug.

      • Perform this step by hand. Do not use any tools.

      • Do not forcibly bend or twist the nylon tube.

      • Protect the disconnected parts by covering them with plastic bags and tape after disconnecting the fuel tubes.

  8. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY


    1. A01BBI4E01

      Disconnect the fuel tank wire connector.

    2. A01BGHUE01

      Press down on the fuel suction with pump and gauge tube assembly and remove the 8 bolts and fuel tank vent tube set plate.

      Note


      • When the fuel tank vent tube set plate is removed, be careful as the fuel suction with pump and gauge tube assembly will spring upward from the force of the spring.

      • Remove any foreign matter around the fuel suction with pump and gauge tube assembly before this operation.

    3. Remove the fuel suction with pump and gauge tube assembly from the fuel tank assembly.

      Note

      Be careful not to bend the arm of the fuel sender gauge assembly.

    4. Remove the fuel suction tube set gasket from the fuel tank assembly.