Click here

ДАТЧИК ТЕМПЕРАТУРЫ ОХЛАЖДАЮЩЕЙ ЖИДКОСТИ СНЯТИЕ

Click here
Click here
  1. Click here

    DISCHARGE FUEL SYSTEM PRESSURE

    (Click here)

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    DRAIN ENGINE COOLANT

    CAUTION:

    Do not remove the radiator reservoir cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

    Tip:

    Collect the engine coolant in a container and dispose of it according to the local regulations.


    1. A01BG4BE01

      Loosen the radiator drain cock plug and drain the engine coolant.

      Table 1. Text in Illustration
      *1 Radiator Reservoir Cap Sub-assembly *2 Radiator Reservoir Assembly
      *3 Radiator Drain Cock Plug *4 Cylinder Block Water Drain Cock Plug
      *5 2-Way - -

    2. Remove the radiator reservoir cap sub-assembly.

    3. Loosen the cylinder block water drain cock plug and drain the engine coolant from the engine.

  4. Click here

    REMOVE THROTTLE BODY ASSEMBLY

    (Click here)

  5. Click here

    REMOVE FUEL INJECTOR ASSEMBLY

    (Click here)

  6. Click here

    REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


    1. Remove the 2 bolts and transmission oil filler tube sub-assembly.

    2. Remove the O-ring from the transmission oil filler tube sub-assembly.

  7. Click here

    REMOVE INTAKE MANIFOLD


    1. Disconnect the vacuum switching valve connector.

    2. Slide the clamp and disconnect the purge line hose from the vacuum switching valve.

    3. A01BGFG

      Detach the 2 wire harness clamps from the wire harness bracket.

    4. Slide the clamp and disconnect the No. 3 PCV hose from the intake manifold.

    5. Slide the clamp and disconnect the vacuum hose from the intake manifold.

    6. A01BI3V

      Remove the bolt and wire harness bracket from the intake manifold.

    7. A01BHIT

      Remove the 5 bolts, 2 nuts and intake manifold.

    8. Remove the gasket from the intake manifold.

  8. Click here

    REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. Disconnect the engine coolant temperature sensor connector.

    2. A01BED7

      Using a 19 mm deep socket wrench, remove the engine coolant temperature sensor and gasket.