VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1419, C1435

DTC Code DTC Name
C1419 Acceleration Sensor Internal Circuit
C1435 Yaw Rate Sensor Internal Circuit

DESCRIPTION

The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system.

The yaw rate sensor has a built-in acceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2).

If there is trouble in the bus lines between the yaw rate and acceleration sensor and the CAN communication system, DTCs U0123 (malfunction in CAN communication with the yaw rate sensor) and U0124 (malfunction in CAN communication with the acceleration sensor) are set.

These DTCs are also output when calibration has not been completed.

DTC Code DTC Detection Condition Trouble Area
C1419 A data malfunction signal is received from the acceleration sensor. Yaw rate and acceleration sensor
C1435 A data malfunction signal is received from the yaw rate sensor. Yaw rate and acceleration sensor

WIRING DIAGRAM

Refer to DTCs C1232, C1243 and C1245 Click here.

INSPECTION PROCEDURE

Note

When replacing the yaw rate and acceleration sensor, perform zero point calibration Click here.

Tech Tips

When U0123, U0124 and/or U0126 is output together with C1419 and/or C1435, inspect and repair the trouble areas indicated by U0123, U0124 and/or U0126 first Click here.

PROCEDURE


  1. REPLACE YAW RATE AND ACCELERATION SENSOR


    1. Replace the yaw rate and acceleration sensor Click here.

      Note

      Check the yaw rate and acceleration sensor signal after replacement Click here.

      Tech Tips

      If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step Click here.


    NEXT

    END