PARK / NEUTRAL POSITION SWITCH INSTALLATION


  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Install the park/neutral position switch to the automatic transmission.

    2. A01BAP6

      Temporarily install the bolt.

    3. A01BFAU

      Install a new lock washer and the nut.

      Torque:
      6.9 N*m  { 70 kgf*cm, 61 in.*lbf }
    4. A01BBPPE01

      Turn the control shaft lever clockwise until it stops, and turn it counterclockwise 2 notches to set it to the N position.

    5. A01BCKQE06

      Align the neutral basic line with the switch groove, and tighten the adjusting bolt.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }
    6. A01BHWF

      Using a screwdriver, bend the tabs of the lock washer.

    7. A01BHSTE01

      Connect the park/neutral position switch connector.

  2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY


    1. A01BDE0E01

      Connect the control cable with a new clip to the bracket.

    2. Temporarily install the control cable to the control shaft lever with the nut.

      Torque:
      15 N*m  { 150 kgf*cm, 10 ft.*lbf }

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Apply the parking break and turn ignition switch on.

    2. Depress the break pedal and check that the engine starts only when the shift lever is set in N or P position and it does not start in other positions.

    3. Check that the back up light is lit and the reverse warning buzzer sounds only when the shift lever is set in R position and these do not function.

    4. If a failure is found, check the park/neutral position switch for continuity.

  5. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. A01BCKQE05

      Loosen the bolt of the park/neutral position switch and move the shift lever to the N position.

    2. Align the groove and the neutral basic line.

    3. Hold the switch in position and tighten the bolt.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

    4. After adjustment, perform the switch operation check.

  6. INSPECT SHIFT LEVER POSITION


    1. When shifting from P position only with ignition switch ON and depress the break pedal.

    2. Make sure that the shifting lever moves smoothly and can be moderately operated.

    3. When starting engine, make sure that the vehicle moves forward when shifting from N to D position and moves reward when shifting R position.

  7. ADJUST SHIFT LEVER POSITION


    1. A01BCKQE05

      Loosen the bolt of the park/neutral position switch and move the shift lever to the N position.

    2. Align the groove and the neutral basic line.

    3. Hold the switch in position and tighten the bolt.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

    4. After adjustment, perform the switch operation check.

  8. PERFORM INITIALIZATION

    Click here