CRANKSHAFT POSITION SENSOR (w/o DPF) INSTALLATION


  1. INSTALL CRANKSHAFT POSITION SENSOR

    A01BAAT

    1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

    2. A01BFNV

      Install the crankshaft position sensor with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not crack or jam the O-ring when installing the crankshaft position sensor.

    3. Connect the 3 wire harness clamps.

    4. A01BB55

      Connect the crankshaft position sensor to the No. 1 vacuum pipe.

    5. Connect the crankshaft position sensor connector.

  2. INSTALL VANE PUMP OIL RESERVOIR ASSEMBLY

    A01BBMO

    1. Install the vane pump oil reservoir assembly with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  4. PERFORM INITIALIZATION


    1. Perform initialization procedures Click here.

      Note

      Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.