Click here

FRONT SEAT OUTER BELT ASSEMBLY(for 3 Door) INSTALLATION

Click here
Click here Click here

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

Tip:

  • Use the same procedure for the RH and LH side.

  • The procedure listed below is for the LH side.

Click here

PROCEDURE


  1. Click here

    INSTALL FRONT SEAT OUTER BELT ASSEMBLY


    1. A0048BSC03
      *1 Retractor
      *a Unlock
      *b Lock
      *c 45°

      Check the angle of inclination required to lock the retractor.


      1. Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45° or more.

        Note:

        Do not disassemble the retractor.

        If the operation is not as specified, replace the front seat outer belt assembly.

    2. A0047Z2E01

      Engage the 2 hooks and temporarily install the front seat outer belt assembly with the 2 bolts.

    3. Tighten bolt A and then bolt B.

      for Bolt A
      12.5 N*m 127 kgf*cm 9 ft.*lbf
      for Bolt B
      42 N*m 428 kgf*cm 31 ft.*lbf

    4. Install the shoulder anchor with the bolt.

      42 N*m 428 kgf*cm 31 ft.*lbf

    5. Install the floor anchor with the bolt.

      42 N*m 428 kgf*cm 31 ft.*lbf

    6. Check that the ELR locks.

      Note:

      • The check should be performed with the front seat outer belt assembly installed.

      • Do not allow the anchor part of the front seat outer belt assembly and the protruding parts of the floor panel to overlap.


      1. With the belt installed, check that the belt locks when it is pulled out quickly.

        If the operation is not as specified, replace the front seat outer belt assembly.

    7. A0049RJC01
      *a Locking Button

      Connect the pretensioner connector.

    8. Lock the locking button.

      Note:

      Securely lock the locking button.

    9. Remove the bolt and floor anchor.

  2. Click here

    INSTALL CENTER PILLAR UPPER GARNISH

    Click here

  3. Click here

    INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY

    Click here

  4. Click here

    CONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. Connect the floor anchor part of the front seat outer belt assembly with the bolt.

      42 N*m 428 kgf*cm 31 ft.*lbf

    2. Engage the 3 claws to install the lap belt outer anchor cover.

  5. Click here

    CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    1. Connect the front door opening trim weatherstrip.

  6. Click here

    INSTALL FRONT DOOR SCUFF PLATE

    Click here

  7. Click here

    INSTALL REAR SEAT ASSEMBLY (for RH Side)

    (Click here)

  8. Click here

    INSTALL REAR SEAT ASSEMBLY (for LH Side)

    (Click here)

  9. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    5.4 N*m 55 kgf*cm 48 in.*lbf
  10. Click here

    INSPECT SRS WARNING LIGHT

    (Click here)