ECM REMOVAL

PROCEDURE


  1. PRECAUTION

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

      Click here

    • Perform the Vehicle Identification Number (VIN) registration when replacing the ECM.

      Click here

    • If the ECM has been struck or dropped, replace it.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE WINDSHIELD WIPER MOTOR AND LINK

    Click here

  4. REMOVE FRONT AIR SHUTTER SEAL RH


  5. REMOVE FRONT NO. 1 VENTILATOR SEAL


  6. REMOVE INNER COWL TOP TO COWL BRACE


  7. REMOVE OUTER COWL TOP PANEL


  8. REMOVE ECM (for LHD)


    1. B00464N

      Lift up the lever to disengage the lock, and disconnect the 2 ECM connectors from the ECM

      Note

      When disconnecting connectors, make sure that foreign substances such as mud or water droplets do not adhere to them.

    2. B0045XP

      Remove the bolt, nut and ECM from the vehicle.

      Note

      If the ECM has been struck or dropped, replace it.

  9. REMOVE ECM (for RHD)


    1. B0046JH

      Lift up the lever to disengage the lock, and disconnect the 2 ECM connectors from the ECM

      Note

      When disconnecting connectors, make sure that foreign substances such as mud or water droplets do not adhere to them.

    2. B0046OT

      Remove the bolt, nut and ECM from the vehicle.

      Note

      If the ECM has been struck or dropped, replace it.

  10. REMOVE NO. 1 ECM BRACKET (for LHD)


    1. B0046E9

      Remove the 2 screws and No. 1 ECM bracket from the ECM.

  11. REMOVE NO. 1 ECM BRACKET (for RHD)


    1. B0045Z9

      Remove the 2 screws and No. 1 ECM bracket from the ECM.

  12. REMOVE NO. 2 ECM BRACKET (for LHD)


    1. B0045IB

      Remove the 2 screws and No. 2 ECM bracket from the ECM.

  13. REMOVE NO. 2 ECM BRACKET (for RHD)


    1. B00479M

      Remove the 2 screws and No. 2 ECM bracket from the ECM.