CAUTION / NOTICE / HINT
Release the vacuum from booster by depressing the brake pedal several times.
Then remove the brake master cylinder from brake booster.
PROCEDURE
REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)
REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)
REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
REMOVE BRAKE ACTUATOR ASSEMBLY
REMOVE FRONT NO. 1 VENTILATOR SEAL
Disengage the clamp to remove the front No. 1 ventilator seal.
REMOVE FRONT AIR SHUTTER SEAL RH
Use the same procedure as for the No. 1 ventilator seal.
REMOVE INNER COWL TOP TO COWL BRACE
Remove the 2 bolts and inner cowl top to cowl brace.
REMOVE OUTER COWL TOP PANEL
Disengage the 2 clamps to separate the wire harness.
Remove the 8 bolts and outer cowl top panel.
SEPARATE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY
SEPARATE BRAKE MASTER CYLINDER PUSH ROD CLEVIS
DISCONNECT VACUUM SENSOR CONNECTOR (w/ Vacuum Sensor)
Disconnect the vacuum sensor connector.
REMOVE BRAKE BOOSTER ASSEMBLY
except 2NR-FKE:
Slide the clip and disconnect the vacuum hose from the brake vacuum check valve assembly.
for 2NR-FKE, CVT:
Slide the 2 clips and disconnect the 2 vacuum hoses from the 2 brake vacuum check valve assemblies.
for 2NR-FKE, Manual Transaxle:
Slide the clip and disconnect the vacuum hose from the brake vacuum check valve assembly.
for 1ND-TV:
Remove the bolt and separate the wire harness bracket.
Remove the 4 nuts and brake booster assembly.
Do not damage the brake tubes.
Remove the gasket from the brake booster assembly.