Click here

REAR SPOILER REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear spoiler removal/installation are shown below.

Table 1. Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedure Effects / Inoperative when not Performed Link
When the luggage compartment door is opened using a mechanical key Initialize luggage closer motor assembly The power trunk lid does not operate

Click here
Click here

PROCEDURE


  1. Click here

    REMOVE LUGGAGE COMPARTMENT DOOR ASSIST GRIP

    Click here

  2. Click here

    REMOVE SWITCH BEZEL

    Click here

  3. Click here

    REMOVE NO. 2 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

    Click here

  4. Click here

    REMOVE LUGGAGE COMPARTMENT DOOR COVER

    Click here

  5. Click here

    REMOVE REAR SPOILER SUB-ASSEMBLY


    1. B004XCH

      Remove the 4 nuts.

    2. B004SIEC02
      B004RMI Protective Tape

      Put protective tape around the rear spoiler sub-assembly.

    3. B004Y7FC01
      B004RMI Remove in this Direction

      Detach the clips and remove the rear spoiler sub-assembly.

  6. Click here

    REMOVE BOLT


    1. B004YECC01
      B004RMI Remove in this Direction - -

      Remove the 3 bolt.