HAZARD WARNING SWITCH REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   REMOVE FRONT DOOR SCUFF PLATE LH

   Click here

2. Click here

   REMOVE COWL SIDE TRIM BOARD LH

   Click here

3. Click here

   REMOVE INSTRUMENT SIDE PANEL LH

   Click here

4. Click here

   REMOVE LOWER NO. 1 INSTRUMENT PANEL PAD SUB-ASSEMBLY

   Click here

5. Click here

   REMOVE INSTRUMENT SIDE PANEL RH

   Click here

6. Click here

   REMOVE NO. 2 CONSOLE UPPER PANEL GARNISH

   Click here

7. Click here

   REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

   Click here

8. Click here

   REMOVE INSTRUMENT PANEL SAFETY PAD INSERT SUB-ASSEMBLY

   Click here

9. Click here

   REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

   Click here

10. Click here

    REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY

    
    
    1. 

       Disconnect the connector.

    2. 

       *a	Rib
       *b	Lower Side Claw
       	Protective Tape
       	Push Here
       	Remove in this Direction

       Insert a thin-bladed screwdriver, into the cutout of the instrument cluster finish panel garnish assembly.

       Tip:

       Tape the thin-bladed screwdriver tip before use.

    3. Slightly tilt the inserted screwdriver to raise the rib and detach the claw on the upper side.

    4. Press the area shown in the illustration to detach the claw on the lower side, and then remove the hazard warning signal switch assembly.