SWITCH HOUSING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL STEERING WHEEL SWITCH HOUSING


    1. B004X6R

      When reusing the steering wheel switch housing:


      1. Using pliers, support the band clamp while loosened and set the steering wheel switch housing.

      2. B004XMWC01
        B004RMI Install in this Direction

        Push the steering wheel switch housing forward to attach the claw to install it.

      3. B004VM1

        Tighten the band clamp.

    2. When installing a new steering wheel switch housing:


      1. B004R2Q

        Set the steering wheel switch in place.

      2. B004UN4C01
        B004RMI Install in this Direction

        Push the steering wheel switch housing forward to attach the claw to install it.

      3. B004XJSC01
        B004RMI Remove in this Direction

        Remove the pin to tighten the band clamp.

  2. INSTALL TURN SIGNAL SWITCH

    Click here

  3. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY

    Click here

  4. INSTALL TILT AND TELESCOPIC SWITCH

    Click here

  5. INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

    Click here

  6. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  7. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  8. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  9. CHECK SRS WARNING LIGHT

    Click here