CAUTION / NOTICE / HINT
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
PROCEDURE
INSTALL SEAT COVER WIRE
INSTALL SEPARATE TYPE REAR SEAT CUSHION COVER LH
When installing a separate type rear seat cushion cover LH, refer to Precaution in order to prevent wrinkles from forming.
Install the separate type rear seat cushion cover LH to the rear seat cushion pad LH.
| *a | Hog Ring Pliers | - | - |
Using hog ring pliers, install the separate type rear seat cushion cover LH to the separate type rear seat cushion pad LH with 14 new hog rings in the order indicated in the illustration.
Be careful not to damage the separate type rear seat cushion cover LH.
Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type rear seat cushion cover LH.
INSTALL SEPARATE TYPE REAR SEAT CUSHION COVER RH
Use the same procedure described for the LH side.
INSTALL SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD LH
INSTALL SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD RH
INSTALL SEAT CUSHION CHECK VALVE WITH HOSE LH (w/ Refresh Seat)
INSTALL SEAT CUSHION CHECK VALVE WITH HOSE RH (w/ Refresh Seat)
INSTALL REAR SEAT CUSHION LOCK HOOK
INSTALL REAR SEAT CUSHION ASSEMBLY LH
INSTALL REAR SEAT CUSHION ASSEMBLY RH
Use the same procedure described for the LH side.
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
PERFORM DIAGNOSTIC SYSTEM CHECK
CHECK SRS WARNING LIGHT
INSPECT SEAT BELT WARNING SYSTEM
w/ Occupant Classification System:
w/o Occupant Classification System:
INSPECT REAR SEAT ASSEMBLY
INSPECT SEAT HEATER SYSTEM
INSPECT CLIMATE CONTROL SEAT SYSTEM
INSPECT SEAT VIBRATION SYSTEM (w/ Refresh Seat)