Click here

REAR CONTROL SWITCH(for Power Seat) REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear power seat switch removal/installation are shown below.

Table 1. Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point LKA/LDA system (for Mono camera type)

for Mono Camera type:Click here

for Stereo Camera type:Click here
Lane control system (for Stereo camera type)
Parking support brake system*
Pre-collision system (for Mono camera type)
Pre-collision system (for Stereo camera type)
Adaptive high beam system

  • Lighting system (EXT)

  • Cornering lights
Variable gear ratio steering system

Click here
Parking assist monitor system

Click here
Panoramic View Monitor System

Click here
Initialize rear door sunshade system Rear door sunshade system

Click here
Initialize power trunk lid system Power trunk lid system

Click here
*: When performing learning using the GTS. Click hereClick here
Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

Click here

PROCEDURE


  1. Click here

    REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    CAUTION:
    B004UM0

    • Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    • If the airbag deploys for any reason, it may cause a serious accident.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. Click here

    REMOVE REAR CENTER NO. 2 SEAT ARMREST PANEL SUB-ASSEMBLY


    1. B004X3BC01
      B004RMI Remove in this Direction

      Detach the clip and claw.

    2. While moving the rear center No. 2 seat armrest panel sub-assembly in the direction indicated by the arrow shown in the illustration, detach the guide to remove it.

  4. Click here

    REMOVE REAR CENTER NO. 2 SEAT ARMREST PANEL


    1. B004YC2C01
      B004RMI Remove in this Direction

      Detach the clip and claw.

    2. While moving the rear center No. 2 seat armrest panel in the direction indicated by the arrow shown in the illustration, detach the guide to remove it.

  5. Click here

    REMOVE REAR POWER SEAT SWITCH WITH BRACKET


    1. B004R3Y

      Remove the 4 screws and disconnect the rear power seat switch with bracket from the rear center seat armrest assembly.

  6. Click here

    REMOVE REAR CENTER SEAT ARMREST BRACKET LH


    1. B004WU3

      Remove the 2 screws and rear center seat armrest bracket LH.

  7. Click here

    REMOVE REAR CENTER SEAT ARMREST BRACKET RH


    1. B004TSL

      Remove the 2 screws and rear center seat armrest bracket RH.

  8. Click here

    REMOVE REAR CENTER SEAT ARMREST COVER


    1. B004TBZ

      Remove the rear center seat armrest cover.

  9. Click here

    REMOVE REAR POWER SEAT SWITCH


    1. B004VOY

      Disconnect the connector.

    2. Detach the clamp and remove the rear power seat switch.