POP UP HOOD ECU INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL PEDESTRIAN DETECTION ECU ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:


      • B004UM0

        Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      • If this procedure is performed without disconnecting the negative (-) auxiliary battery terminal of the battery, the pop up hood lifter may deploy even if an impact is applied only to the pedestrian detection ECU assembly. Therefore, make sure that the negative (-) auxiliary battery terminal of the battery is disconnected before performing this procedure.

    3. B004UJ8C01
      *a Water Resistant Sheet
      B004RMI Lock in this Direction

      Check if the water resistant sheet is not torn or peeled off.

    4. Install the pedestrian detection ECU assembly with the 2 nuts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

      Note


      • Do not reuse the pedestrian detection ECU assembly if subjected to any strong impact (such as dropping) during operation.

      • When the power switch is first turned on (IG) after the pedestrian detection ECU assembly has been replaced, make sure that no one is in the vehicle.

    5. Connect the connector and lock it with the lock lever.

      Note

      Do not allow the water resistant sheet to become pinched.

    6. Check that there is no looseness in the installed pedestrian detection ECU assembly.

    7. for RHD:


      1. B004UJ4

        Return the No. 1 console box duct to its original position.

      2. B004W47

        Install the 2 clips.

  2. INSTALL CONSOLE BOX ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  5. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  6. CHECK SRS WARNING LIGHT

    Click here