CAUTION / NOTICE / HINT
-
Use the same procedure for RHD and LHD vehicles.
-
The procedure listed below is for LHD vehicles.
PROCEDURE
- Click here
INSTALL AIRBAG ECU ASSEMBLY
-
Check that the power switch is off.
-
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
CAUTION:
-
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
-
If this procedure is performed without disconnecting the negative (-) auxiliary battery terminal, the airbag may deploy even if an impact is applied only to the airbag ECU assembly. Therefore, make sure that the negative (-) auxiliary battery terminal is disconnected before performing this procedure.
-
-
Install the airbag ECU assembly with the 3 bolts.
17.5 N*m 178 kgf*cm 13 ft.*lbf Note:
-
If the airbag ECU assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the airbag ECU assembly with a new one.
-
When installing the airbag ECU assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
-
When the power switch is first turned to ON after the airbag ECU assembly has been replaced, make sure that no one is in the vehicle.
-
-
Push in Connect the 3 connectors and push in the lock lever to lock the connector.
Note:When connecting any airbag connector, take care not to damage the airbag wire harness.
-
Check that there is no looseness in the installation parts of the airbag ECU assembly.
-
- Click here
INSTALL CONSOLE BOX ASSEMBLY
- Click here
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Note:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
- Click here
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
- Click here
PERFORM DIAGNOSTIC SYSTEM CHECK
- Click here
CHECK SRS WARNING LIGHT