Click here

CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION

Click here
Click here Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

Click here

PROCEDURE


  1. Click here

    INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH


    1. Check that the power switch is turned off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:
      B004UM0

      • Do not begin this procedure within 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal.

      • If the airbag deploys for any reason, it may cause a serious accident.

    3. When reusing the curtain shield airbag assembly LH:

      Install a new clip B to the curtain shield airbag assembly LH.

    4. Attach the clip B and hook to set the curtain shield airbag assembly LH inflator.

    5. Temporarily install the curtain shield airbag assembly LH inflator with new 2 bolts.

    6. Temporarily install the deployment portion of the curtain shield airbag assembly LH with new 4 bolts.

    7. Check that there is no twisting in the deployment portion of the curtain shield airbag assembly LH.

    8. Attach the claw.

    9. Attach the claw to install a new clip A.

      Note:

      Do not push the pin and lock the clip at this time.

      Tip:

      Use the same procedure for the opposite side.

    10. Tighten the 6 bolts.

      10.7 N*m 109 kgf*cm 8 ft.*lbf
    11. B004TH3C01
      *a Clip A *b Clip B

      Push the pin to lock the clip A.

      Tip:

      Use the same procedure for the opposite side.

    12. B004UTLC01
      *a Lock Button
      B004RMI Push

      Connect the airbag connector and push the lock button to lock.

      Note:

      • When connecting any airbag connector, take care not to damage the airbag wire harness.

      • Make sure the lock button is securely locked.

  2. Click here

    INSTALL ROOF HEADLINING ASSEMBLY

    Click here

  3. Click here

    CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. Click here

    INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  5. Click here

    PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  6. Click here

    CHECK SRS WARNING LIGHT

    Click here

  7. Click here

    PERFORM SYSTEM CALIBRATION (w/ Occupant Classification System)

    Click here