FRONT PASSENGER AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY


    1. B004SYDC01
      B004V32 Hold Here

      While holding the positions shown in the illustration, attach the instrument panel passenger airbag assembly hook near the front of the vehicle to the airbag door wall near the front of the vehicle.

    2. Slowly lower the instrument panel passenger airbag assembly to attach the instrument panel passenger airbag assembly hook near the rear of the vehicle to the airbag door wall near the rear of the vehicle.

    3. B004TTU

      Install the 2 screws.

  2. INSTALL NO. 2 INSTRUMENT PANEL WIRE


    1. B004TKCC01
      *a Lock Button
      B004RMI Push

      Attach the wire harness clamp.

    2. Connect the airbag connector and push the lock button to lock.

      Note


      • When connecting any airbag connector, take care not to damage the airbag wire harness.

      • Be sure to connect the connectors to each corresponding color.

      • Make sure the lock button is securely locked.

      Tech Tips

      Use the same procedure for the opposite side.

  3. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT

    Click here

  4. INSTALL NO. 5 HEATER TO REGISTER DUCT

    Click here

  5. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  6. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  7. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  8. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  9. CHECK SRS WARNING LIGHT

    Click here