KNEE AIRBAG ASSEMBLY(for Front Passenger Side) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:


      • Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      • If the airbag deploys for any reason, it may cause a serious accident.

      B004UM0
    3. B004TEHC01
      *a Lock Button
      B004RMI Push

      While holding the lower No. 2 instrument panel airbag assembly with one hand, connect the airbag connector and push the lock button to lock it.

      Note


      • When connecting any airbag connector, take care not to damage the airbag wire harness.

      • Make sure the lock button is securely locked.

    4. B004TVFC01
      B004RMI Install in this Direction

      Attach the claw to install the lower No. 2 instrument panel airbag assembly.

    5. B004RX5

      Install the 2 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  2. INSTALL NO. 2 CONSOLE UPPER PANEL GARNISH

    Click here

  3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  4. INSTALL INSTRUMENT SIDE PANEL RH

    Click here

  5. INSTALL COWL SIDE TRIM BOARD RH

    Click here

  6. INSTALL FRONT DOOR SCUFF PLATE RH

    Click here

  7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  8. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  9. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  10. CHECK SRS WARNING LIGHT

    Click here