Click here

KNEE AIRBAG ASSEMBLY(for Driver Side) DISPOSAL

Click here
Click here Click here

CAUTION / NOTICE / HINT

CAUTION:

Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre-disposal deployment may be considered hazardous material treatment.

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

Click here

PROCEDURE


  1. Click here

    PRECAUTION

    CAUTION:

    • An airbag or pretensioner may be activated by static electricity. To prevent this, be sure to touch a metal surface with your bare hands to discharge static electricity before performing this procedure.

    • Do not perform this procedure indoors or on rough roads where safety cannot be ensured. Also, do not deploy SRS parts near residential areas.

    • B004V8C

      If this procedure is performed indoors or on rough roads where safety cannot be ensured, unforeseen injuries may occur. Also, the deployment noise creates a nuisance to nearby residents.

    Tip:

    When scrapping a vehicle equipped with an SRS or disposing of the lower No. 1 instrument panel airbag assembly, be sure to deploy the airbag first in accordance with the procedure described below. If any abnormality occurs with the airbag deployment, contact the Service Dept. of the distributor.

  2. Click here

    DISPOSE OF LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (When Installed to Vehicle)

    Note:

    • When disposing of the lower No. 1 instrument panel airbag assembly, use an unneeded vehicle to deploy the airbag.

    • Be sure to observe the following procedure when deploying the airbag.

    Tip:

    Prepare a battery as the power source to deploy the airbag.


    1. B004YBUN08

      Check the function of SST.

      Click here

      09082-00700

    2. Refer to Precaution.

      Click here

    3. Remove the luggage compartment mat sub-assembly.

      Click here

    4. Disconnect the cable from the negative (-) auxiliary battery terminal.

      Click here

      CAUTION:
      B004UM0

      • Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      • If the airbag deploys for any reason, it may cause a serious accident.

    5. Remove the lower No. 1 instrument panel airbag assembly.

      Click here

    6. Install SST.


      1. B004X67N01

        After connecting the following SST to each other, connect them to the lower No. 1 instrument panel airbag assembly.

        09082-00802 09082-10801 09082-20801

      2. Install the lower No. 1 instrument panel airbag assembly.

        Click here

        CAUTION:
        B004RAK

        • Do not deploy if the lower No. 1 instrument panel airbag assembly is loose.

        • If deployed while the lower No. 1 instrument panel airbag assembly is loose, the lower No. 1 instrument panel airbag assembly may fly off and cause serious injuries.

      3. B004S4AN01

        Connect SST together (09082-00700 and 09082-10801).

        09082-00700
        Note:

        To avoid damaging SST connector or wire harness, do not lock the secondary lock of the twin lock.

      4. B004XNKC47
        *a 10 m (32.8 ft.) or more

        Move SST at least 10 m (32.8 ft.) away from the front side window of the vehicle.

      5. While maintaining sufficient clearance for SST wire harness in the front side window, close all doors and windows of the vehicle.

        CAUTION:
        B004TIQ

        • Do not deploy with all the doors and door windows open.

        • If deployed with all the doors and door windows open, dust and gas may enter the eyes or be breathed in.

        Note:

        Take care not to damage SST wire harness.

      6. Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.

    7. Deploy the airbag.


      1. Check that no one is inside the vehicle or within a 10 m (32.8 ft.) radius of the vehicle.

      2. Press SST activation switch and deploy the airbag.

        CAUTION:
        B004SHS

        • Do not deploy with people inside or around the vehicle.

        • If deployed with people inside or around the vehicle, serious injuries may occur.

        Tip:

        The airbag is deployed as the LED of SST activation switch comes on.

    8. Remove the lower No. 1 instrument panel airbag assembly.

      Click here

      CAUTION:

      • B004U6B

        The lower No. 1 instrument panel airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after deployment.

      • If not left alone for 30 minutes or more, burns may occur when touched.

      • B004RPT

        Do not apply water etc. to a lower No. 1 instrument panel airbag assembly with a deployed airbag.

      • If water is applied to the lower No. 1 instrument panel airbag assembly immediately after deployment, burns may occur from the resulting steam.

      • B004U2N

        Always wear safety glasses and gloves when handling a deployed lower No. 1 instrument panel airbag assembly.

      • If the lower No. 1 instrument panel airbag assembly is touched without wearing safety glasses and gloves, hot parts may cause burns and dust may enter the eyes.

      • After removal, quickly seal the lower No. 1 instrument panel airbag assembly in a plastic bag.

    9. Dispose of the lower No. 1 instrument panel airbag assembly.


      1. Place the lower No. 1 instrument panel airbag assembly in a plastic bag, tie it tightly and dispose of it according to local regulations.

        CAUTION:

        • B004WXZ

          The lower No. 1 instrument panel airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after deployment.

        • If not left alone for 30 minutes or more, burns may occur when touched.

        • B004UG4

          Do not apply water etc. to a lower No. 1 instrument panel airbag assembly with a deployed airbag.

        • If water is applied to the lower No. 1 instrument panel airbag assembly immediately after deployment, burns may occur from the resulting steam.

        • B004RRA

          Always wear safety glasses and gloves when handling a deployed lower No. 1 instrument panel airbag assembly.

        • If the lower No. 1 instrument panel airbag assembly is touched without wearing safety glasses and gloves, hot parts may cause burns and dust may enter the eyes.

        • B004W1X

          Never dispose of a lower No. 1 instrument panel airbag assembly with an undeployed airbag.

        • If an undeployed lower No. 1 instrument panel airbag assembly is disposed of, and then deploys for any reason, unforeseen injuries may occur.

        • Always wash your hands with water after completing the operation.

  3. Click here

    DISPOSE OF LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (When not Installed to Vehicle)

    Note:

    Be sure to observe the following procedure when deploying the airbag.

    Tip:

    Prepare a battery as the power source to deploy the airbag.


    1. B004YBUN08

      Check the function of SST.

      Click here

      09082-00700

    2. Refer to Precaution.

      Click here

    3. Remove the luggage compartment mat sub-assembly.

      Click here

    4. Disconnect the cable from the negative (-) auxiliary battery terminal.

      Click here

      CAUTION:
      B004UM0

      • Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      • If the airbag deploys for any reason, it may cause a serious accident.

    5. Remove the lower No. 1 instrument panel airbag assembly.

      Click here

    6. B004WQQC91
      *a Wire Diameter
      B004VGX Stripped Wire

      Using braided wire, tie down the lower No. 1 instrument panel airbag assembly to an unneeded tire.

      Wire
      Cross-sectional area of stripped wire
      1.25 mm2 (0.0019 in.2) or more
      CAUTION:

      If the wire harness is too thin or an alternative object is used to tie down the lower No. 1 instrument panel airbag assembly, it may snap when the airbag is deployed. Always use a wire for vehicle use with a cross-sectional area of at least 1.25 mm2 (0.0019 in.2).

      Tip:

      To calculate the area of the cross-sectional area of stripped wire:

      Area = 3.14 x (Diameter)2 / 4


      1. B004WCRC01
        *a Width *b Inner Diameter
        *c Deployment Side - -

        Position the lower No. 1 instrument panel airbag assembly inside the tire with the airbag deployment side facing inside.

        Minimum tire size
        Must exceed the following dimensions
        Width
        185 mm (7.28 in.)
        Inner diameter
        360 mm (1.18 ft.)
        CAUTION:
        B004VFVC01
        *a Remove looseness
        B004VGX Deployment Side

        • Do not install the lower No. 1 instrument panel airbag assembly with the deployment side facing outside.

        • When securing the lower No. 1 instrument panel airbag assembly, make sure there is no looseness in the wire harness.

        • If the deployment side is facing outside or the wire harness is loosely wrapped, the deployed lower No. 1 instrument panel airbag assembly and tire may fly off and cause serious injuries.

        Note:

        The tires may be damaged by the airbag deployment, so use unneeded tires.

    7. Install SST.


      1. B004Y5XN01

        After connecting the following SST to each other, connect them to the lower No. 1 instrument panel airbag assembly.

        09082-00802 09082-10801 09082-20801

    8. Place the tires.


      1. B004UFRC01
        *a Tires (2 or more)

        Place at least 2 tires under the tire to which the lower No. 1 instrument panel airbag assembly is tied.

        Note:

        Do not place SST connector under the tire because it could be damaged.

      2. Place at least 2 tires onto the tire to which the lower No. 1 instrument panel airbag assembly is tied. The top tire should have a wheel installed.

        Note:

        The wheel and tires may be damaged by the airbag deployment, so use an unneeded wheel and tires.

      3. B004T13

        Tie the tires together with 2 wires.

        CAUTION:

        Make sure that the wires are tight. Looseness in the wires will result in the tires breaking loose when the airbag is deployed.

    9. Install SST.


      1. B004VN8C01
        *a 10 m (32.8 ft.) or more

        Connect SST together (09082-00700 and 09082-10801).

        09082-00700
        Note:

        To avoid damaging SST connector or wire harness, do not lock the secondary lock of the twin lock. Also, secure some slack for SST wire harness inside the tire.

      2. Move SST at least 10 m (32.8 ft.) away from the airbag tied down to the tire.

    10. Deploy the airbag.


      1. Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.

      2. Check that no one is within a 10 m (32.8 ft.) radius of the tire to which the lower No. 1 instrument panel airbag assembly is tied.

      3. Press SST activation switch to deploy the airbag.

        CAUTION:
        B004WT9

        • Do not deploy with people around the tire.

        • If deployed with people around the tire, serious injuries may occur.

        Tip:

        The airbag is deployed as the LED of SST activation switch comes on.

    11. Dispose of the lower No. 1 instrument panel airbag assembly.

      CAUTION:

      • B004WXZ

        The lower No. 1 instrument panel airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after deployment.

      • If not left alone for 30 minutes or more, burns may occur when touched.

      • B004UG4

        Do not apply water etc. to a lower No. 1 instrument panel airbag assembly with a deployed airbag.

      • If water is applied to the lower No. 1 instrument panel airbag assembly immediately after deployment, burns may occur from the resulting steam.

      • B004RRA

        Always wear safety glasses and gloves when handling a deployed lower No. 1 instrument panel airbag assembly.

      • If the lower No. 1 instrument panel airbag assembly is touched without wearing safety glasses and gloves, hot parts may cause burns and dust may enter the eyes.

      • B004W1X

        Never dispose of a lower No. 1 instrument panel airbag assembly with an undeployed airbag.

      • If an undeployed lower No. 1 instrument panel airbag assembly is disposed of, and then deploys for any reason, unforeseen injuries may occur.

      • Always wash your hands with water after completing the operation.


      1. Remove the lower No. 1 instrument panel airbag assembly from the tire.

      2. Place the lower No. 1 instrument panel airbag assembly in a plastic bag, tie it tightly, and dispose of it according to local regulations.