Click here

STEERING PAD INSTALLATION

Click here
Click here Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

Click here

PROCEDURE


  1. Click here

    INSTALL HORN BUTTON ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:
      B004UM0

      • Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      • If the airbag deploys for any reason, it may cause a serious accident.

    3. B004YEWC01
      *a Lock Button
      *b Wire Harness Clamp
      B004SZX Airbag Connector
      B004UK4 Horn Connector
      B004RMI Push

      Support the horn button assembly with one hand.

    4. Connect the horn connector and attach the wire harness clamp.

    5. Connect the airbag connector and push the lock button.

      Note:

      • When connecting any airbag connector, take care not to damage the airbag wire harness.

      • Be sure to connect the connectors to each corresponding color.

      • Make sure the lock button is securely locked.

    6. Set the horn button assembly to the steering wheel assembly.

    7. Check that the airbag wire harness and horn wire harness are not pinched.

    8. B004X9ZC01
      *a Upper Pin
      *b Lower Pin

      Press the horn button assembly with both hands to attach the upper pin to the upper spring.

    9. Press the horn button assembly with both hands to attach the lower pin to the lower spring.

      Note:

      After installation, try to pull the horn button assembly and check that the horn button assembly is securely installed.

  2. Click here

    INSTALL LOWER NO. 3 STEERING WHEEL COVER


    1. Attach the guide and claw to install the lower No. 3 steering wheel cover.

  3. Click here

    INSTALL LOWER NO. 2 STEERING WHEEL COVER


    1. Attach the guide and claw to install the lower No. 2 steering wheel cover.

  4. Click here

    CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  5. Click here

    INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  6. Click here

    INSPECT HORN BUTTON ASSEMBLY


    1. Make sure that the horn sounds.

      If the horn does not sound, inspect the horn system.

      Click here

  7. Click here

    PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  8. Click here

    CHECK SRS WARNING LIGHT

    Click here