REAR SEAT SIDE AIRBAG ASSEMBLY(for Fixed Seat Type) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR SEAT AIRBAG ASSEMBLY LH


    1. B004TXSC01
      B004RMI Install in this Direction

      Set the rear seat airbag assembly LH into place.

    2. Install the rear seatback panel LH with 4 new nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      CAUTION:


      • Do not reuse the nut.

      • If the installation surface or surrounding area of the rear seat airbag assembly LH is deformed or damaged, replace the rear seatback pad sub-assembly with a new one.

    3. B004W4I

      Connect the strap with a new nut.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      CAUTION:

      Do not reuse the nut.

    4. B004XP4

      Attach the wire harness clamp.

    5. B004W5OC01
      *a Hog Ring Pliers

      Return the rear seatback cover to its original position and using hog ring pliers, install 3 new hog rings.

      Note


      • Be careful not to damage the rear seatback cover.

      • Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the rear seatback cover.

  2. INSTALL REAR SEATBACK ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  5. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  6. CHECK SRS WARNING LIGHT

    Click here