Click here

COMBINATION METER REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

Note:

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

Click here

PROCEDURE


  1. Click here

    CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

    Click here

  2. Click here

    REMOVE INSTRUMENT SIDE PANEL LH

    Click here

  3. Click here

    REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  4. Click here

    REMOVE LOWER NO. 1 INSTRUMENT PANEL PAD SUB-ASSEMBLY

    Click here

  5. Click here

    REMOVE NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  6. Click here

    REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD

    Click here

  7. Click here

    REMOVE INSTRUMENT PANEL SAFETY PAD INSERT SUB-ASSEMBLY

    Click here

  8. Click here

    REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

    Click here

  9. Click here

    REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

    Click here

  10. Click here

    REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    1. B004YPJC01
      B004V32 Place Hand Here
      B004RMI Remove in this Direction

      Detach the claw and guide as shown in the illustration.

    2. B004RS8C01
      *A except Sport Package, w/ Illumination
      B004V32 Place Hands Here
      B004RMI Remove in this Direction

      except Sport Package, w/ Illumination:


      1. Disconnect the connector.

    3. Place both hands at the position shown in the illustration and pull towards the rear of the vehicle to detach the clip and guide and remove the instrument cluster finish panel assembly.

    4. B004WJ3

      Disconnect the connector.

  11. Click here

    REMOVE COMBINATION METER ASSEMBLY


    1. except Sport Package:


      1. B004XMZC01
        *A w/ Illumination

        Detach the clamp.

      2. w/ Illumination:

        Detach the clamp.

      3. Remove the 4 screws.

      4. B004S9SC01
        B004RMIC51 Remove in this Direction

        Pull in the direction of the arrow in the illustration and detach the pin and remove the combination meter assembly.

    2. B004XUK

      for Sport Package:


      1. Detach the clamp.

      2. Remove the 4 screws.

      3. B004X6WC01
        B004RMI Remove in this Direction

        Pull in the direction of the arrow in the illustration and detach the pin and remove the combination meter assembly.

    3. B004RXQ

      Detach the wire harness clamp and disconnect the 2 connectors.