ELECTRICAL KEY OSCILLATOR(for Roof) INSTALLATION

PROCEDURE

1. Click here

   INSTALL ROOF HEADER ELECTRICAL KEY ANTENNA

   
   

   1. Insert the guide into the roof panel hole, and install the roof header electrical key antenna with the nuts.

      14 N*m

      143 kgf*cm

      10 ft.*lbf

      Note:

      Do not touch the contact terminal of the roof header electrical antenna.

      Tip:

      There is a protective cover on the new roof header electrical antenna. Remove this cover before replacing parts.

   2. 

      Nut

      Connector

      Connect the connector.

2. Click here

   INSTALL ROOF HEADLINING ASSEMBLY

   Click here

3. Click here

   CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Click here

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

4. Click here

   INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

   Click here

5. Click here

   INSPECT SRS WARNING LIGHT

   Click here

6. Click here

   PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK (for Front Passenger Side)

   Click here

7. Click here

   INSPECT FRONT SEAT ASSEMBLY

   Click here

8. Click here

   INSPECT REAR SEAT ASSEMBLY (for Power Seat)

   Click here

9. Click here

   INSPECT SEAT HEATER SYSTEM (w/ Seat Heater System)

   Click here

10. Click here

    INSPECT CLIMATE CONTROL SEAT SYSTEM (w/ Climate Control Seat System)

    Click here

11. Click here

    INSPECT SEAT VIBRATION SYSTEM (w/ Refresh Seat)

    Click here

12. Click here

    INSPECT SEAT BELT WARNING SYSTEM

    
    

    1. w/o Occupant Classification System:

       Click here

    2. w/ Occupant Classification System:

       Click here