BLIND SPOT MONITOR SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during blind spot monitor sensor removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effect/Inoperative Function When Necessary Procedures are not Performed	Link
Disconnect cable from negative (-) auxiliary battery terminal	Memorize steering angle neutral point	LKA/LDA system (for Mono camera type)	for Stereo Camera type: Click here for Mono Camera type: Click here
		Lane control system (for Stereo camera type)
		Parking support brake system*
		Pre-collision system (for Stereo camera type)
		Pre-collision system (for Mono camera type)
		Adaptive high beam system
		Lighting system (EXT) Cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic view monitor system	Click here
	Initialize rear door sunshade system	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here
Rear bumper assembly (Including removal and installation)	Ultrasonic sensor detection angle Ultrasonic sensor detection angle registration	Parking support brake system	Click here
Blind spot monitor sensor	Blind spot monitor beam axis confirmation	DTCs are output Parking support alert system Parking support brake system Blind spot monitor system Lane control system (for Stereo camera type) Pre-collision system (for Stereo camera type)	Click here
When the luggage compartment door is opened using a mechanical key	Initialize luggage closer motor assembly	The power trunk lid does not operate	Click here

*: When performing learning using the GTS.
Click here Click here

PROCEDURE

REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Hands Free Power Trunk Lid)

Click here
DISCONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (w/ Hands Free Power Trunk Lid)
1. Disconnect the cable from the negative (-) auxiliary battery terminal.
  
  Click here
  CAUTION:
  
  Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
  
  If the airbag deploys for any reason, it may cause a serious accident.
  Note
  
  When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
  
  Click here
REMOVE REAR BUMPER ASSEMBLY

Click here
REMOVE BLIND SPOT MONITOR COVER LH
1. Remove in this Direction
  
  Detach the claw, guide and remove the blind spot monitor cover LH the direction of the arrow shown in the illustration.
REMOVE BLIND SPOT MONITOR COVER RH

Tech Tips

Use the same procedure described for the LH side.
REMOVE BLIND SPOT MONITOR SENSOR LH
1. Nut
  
  Connector
  
  Disconnect the connector.
2. Remove the 3 nuts and blind spot monitor sensor LH.
  
  Note
  
  If the removed nut is the same shape as that shown in the illustration, replace it the supplied replacement part.
REMOVE BLIND SPOT MONITOR SENSOR RH

Tech Tips

Use the same procedure described for the LH side.

	Nut
	Connector