DTC Code | DTC Name |
---|---|
C1682 | Front Camera Current Malfunction |
DESCRIPTION
This DTC is stored if the parking assist ECU judges as a result of its self check that there is a problem with the current supplied from the front television camera assembly connected to the parking assist ECU.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
---|---|---|---|
C1682 | Front Camera Current Malfunction | Open or short in the front television camera signal circuit |
|
CAUTION / NOTICE / HINT
When "!" mark is displayed on the multi-display assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as panoramic view monitor system may be needed.
PROCEDURE
CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - FRONT TELEVISION CAMERA ASSEMBLY)
Disconnect the G95 parking assist ECU connector.
Disconnect the C5 front television camera assembly connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance | |||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Measure the voltage according to the value(s) in the table below.
Standard Voltage | |||||||||
---|---|---|---|---|---|---|---|---|---|
|
Result | |||
---|---|---|---|
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
CHECK PARKING ASSIST ECU (BCB+, BGND)
*a | Component with harness connected (Parking Assist ECU) |
Disconnect the front television camera assembly connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance | ||||||
---|---|---|---|---|---|---|
|
Measure the voltage according to the value(s) in the table below.
Standard Voltage | |||||||||
---|---|---|---|---|---|---|---|---|---|
|
Result | |||
---|---|---|---|
|
REPLACE FRONT TELEVISION CAMERA ASSEMBLYClick here
REPLACE PARKING ASSIST ECUClick here