BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:C1A46

DESCRIPTION

The blind spot monitor sensor receives yaw rate signals from the yaw rate sensor via CAN communication.

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   CHECK DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)

   
   

   1. Check for electronically controlled brake system DTCs.

      Click here

      OK
      Electronically controlled brake system DTCs are not output.

      Result
      Proceed to OK NG

   
   
   • OKClick here
   • NG

     GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEMClick here

2. Click here

   RECHECK DTC

   
   

   1. Turn the power switch off.

   2. Turn the power switch on (IG).

   3. Recheck for DTCs and check if the same DTC is output again.

      
      
      1. Body Electrical > Blind Spot Monitor Master > Trouble Codes
      2. 
         
      3. 
         
      
      
      1. Body Electrical > Blind Spot Monitor Slave > Trouble Codes
      2. 
         
      3. 
         

      Result
      Result Proceed to No DTCs are output. A DTC C1A46 is output ("Blind Spot Monitor Master"). B DTC C1A46 is output ("Blind Spot Monitor Slave"). C

   
   
   • A

     USE SIMULATION METHOD TO CHECKClick here

   • B

     REPLACE BLIND SPOT MONITOR SENSOR RHClick here

   • C

     REPLACE BLIND SPOT MONITOR SENSOR LHClick here