| DTC Code | DTC Name |
|---|---|
| C1626 | Steering Angle Sensor Failure |
DESCRIPTION
This DTC is stored if the clearance warning ECU assembly receives a signal via CAN communication from the steering sensor that indicates an internal malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1626 | Steering Angle Sensor Failure | A fail flag is transmitted from the steering sensor |
|
CAUTION / NOTICE / HINT
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
After replacing an ultrasonic sensor or the clearance warning ECU assembly, perform the necessary procedures (adjustment, calibration, initialization or registration).
When continuing with the inspection, confirm that the necessary procedures (adjustment, calibration, initialization or registration) have been completed before proceeding.
PROCEDURE
REPLACE STEERING SENSOR
Replace the steering sensor with a new or known good one.
| Result | ||
|---|---|---|
|
CHECK DTC OUTPUT
Using the GTS, check for DTCs according to the prompts on the screen.
After turning the power switch from off to on (IG), wait 4 seconds or more before
Clear the DTCs according to the screen on the GTS.
Recheck for DTCs.
| Result | ||||||
|---|---|---|---|---|---|---|
|
REPLACE CLEARANCE WARNING ECU ASSEMBLYClick here
END (STEERING SENSOR DEFECTIVE)