Click here

NAVIGATION SYSTEM, Diagnostic DTC:B155B

Click here
Click here
DTC Code DTC Name
B155B Touch Pad Memory Module Malfunction
Click here

DESCRIPTION

This DTC is stored if the remote operation controller assembly (remote touch) detects a malfunction in itself, such as internal hardware failure or touch pad memory module malfunction.

DTC No. Detection Item DTC Detection Condition Trouble Area
B155B Touch Pad Memory Module Malfunction Internal memory module malfunction Remote operation controller assembly (remote touch)
Click here

PROCEDURE


  1. Click here

    CHECK DTC


    1. Clear the DTCs.

      Click here


      1. Body Electrical > Navigation System > Clear DTCs


    2. Recheck for DTCs and check that no DTCs are output.

      Click here


      1. Body Electrical > Navigation System > Trouble Codes


      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG

  2. Click here

    CHECK INFORMATION CODE


    1. Check that the part number of the remote operation controller assembly (remote touch) is correct.

      Result
      Result Proceed to
      The part number of the remote operation controller assembly (remote touch) is correct A
      The part number of the remote operation controller assembly (remote touch) is incorrect B

  3. Click here

    REMOTE TOUCH SELF CHECK (CHECK TOUCH SCREEN OPERATION POSITION RECOGNITION CONDITION)


    1. Enter self-diagnostic mode.

      Click here

    2. Operate the remote touch screen laterally and check that the touch screen generates vibration feedback.

      Note:

      Since the remote touch screen may recognize a pinch in/out or flick operation if operated with 2 fingers, always use 1 finger to operate the remote touch in self-diagnostic mode.

      Tip:

      When operating at an excessively low temperature, vibration feedback may be difficult to feel.

      Result
      Result Proceed to
      Vibration feedback is generated according to touch panel operation A
      The switch illumination changes but vibration feedback is not generated in accordance to touch screen operation B

  4. Click here

    CHECK DTC


    1. Clear the DTCs.

      Click here


      1. Body Electrical > Navigation System > Clear DTCs


    2. Turn the power switch off.

    3. Turn the power switch on (ACC) and wait for 5 seconds.

    4. Recheck for DTCs and check that no DTCs are output.

      Click here


      1. Body Electrical > Navigation System > Trouble Codes


      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG

    • OK

      USE SIMULATION METHOD TO CHECKClick here

    • NG

      REPLACE REMOTE OPERATION CONTROLLER ASSEMBLY (REMOTE TOUCH)Click here