Click here

AUDIO AND VISUAL SYSTEM, Diagnostic DTC:B153A

Click here
Click here
DTC Code DTC Name
B153A GVIF Disconnected (from Extension Module to H/U)
Click here

DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
B153A GVIF Disconnected (from Extension Module to H/U) GVIF disconnected (from navigation ECU to radio receiver assembly)

  • No.1 navigation wire

  • Navigation ECU

  • Radio receiver assembly
Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

When replacing the radio receiver assembly or navigation ECU, always replace it with a new one.

If a radio receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:


  • A communication malfunction DTC may be stored.

  • The radio receiver assembly or navigation ECU may not operate normally.

Tip:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

Click here

Click here

PROCEDURE


  1. Click here

    CHECK DTC


    1. Clear the DTCs.

      Click here


      1. Body Electrical > Navigation System > Clear DTCs


    2. Recheck for DTCs and check that no DTCs are output.


      1. Body Electrical > Navigation System > Trouble Codes


      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG

  2. Click here

    CHECK NO. 1 NAVIGATION WIRE (RADIO RECEIVER ASSEMBLY - NAVIGATION ECU)


    1. B004TB7C26
      *a

      Front view of wire harness connector

      (to Navigation ECU)
      *b

      Front view of wire harness connector

      (to Radio Receiver Assembly)

      Disconnect the G158 navigation ECU connector.

    2. Disconnect the G157 radio receiver assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G158-1 (GVO-) - G157-1 (GV2-) Always Below 1 Ω
      G158-2 (GVO+) - G157-2 (GV2+) Always Below 1 Ω
      G158-3 (GVG1) - G157-3 (GVG2) Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

  3. Click here

    REPLACE NAVIGATION ECU


    1. Replace the Navigation ECU with a new one.

      Click here

      Result
      Proceed to
      NEXT

  4. Click here

    CHECK DTC


    1. Clear the DTCs.

      Click here


      1. Body Electrical > Navigation System > Clear DTCs


    2. Recheck for DTCs and check that no DTCs are output.


      1. Body Electrical > Navigation System > Trouble Codes


      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG

    • OK

      END (NAVIGATION ECU IS DEFECTIVE)

    • NG

      REPLACE RADIO RECEIVER ASSEMBLYClick here