Click here

TILT AND TELESCOPIC MANUAL SWITCH INSTALLATION

Click here
Click here

CAUTION / NOTICE / HINT

Note:

  • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the power switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the power switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

Click here

PROCEDURE


  1. Click here

    INSTALL TILT AND TELESCOPIC SWITCH


    1. Engage the claw to install the tilt and telescopic switch.

    2. Connect the tilt and telescopic connector to the tilt and telescopic switch.

    3. Connect the airbag connector to the spiral cable with sensor sub-assembly.

  2. Click here

    INSTALL LOWER STEERING COLUMN COVER


    1. B004XPXC01
      *a Felt
      B004RMI Install in this Direction

      Insert the lower steering column cover sub-assembly in the direction indicated by the arrow.

      Note:

      Do not damage the tilt and telescopic switch and felt.

    2. Engage the 4 claws to install the lower steering column cover sub-assembly to the upper steering column cover.

    3. Install the 3 screws.

  3. Click here

    CONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. Click here

    INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  5. Click here

    CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM


    1. Reset the auto tilt away function setting to the previous condition by changing the customize parameter.

      Click here