DYNAMIC REAR STEERING SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   VEHICLE BROUGHT TO WORKSHOP

   Result
   Proceed to NEXT

   
   
   • NEXTClick here
2. Click here

   INSPECT AUXILIARY BATTERY VOLTAGE

   Standard voltage
   11 to 14 V (Power switch off)

   If the voltage is less than 11 V, recharge or replace the auxiliary battery before proceeding.

   Result
   Proceed to NEXT

   
   
   • NEXTClick here
3. Click here

   CHECK CAN COMMUNICATION SYSTEM*

   
   

   1. Use the GTS to check if the CAN communication system is functioning normally.

      Click here

      Result
      Result Proceed to CAN DTCs are not output. A CAN DTCs are output. B

   
   
   • AClick here
   • B

     GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)Click here

4. Click here

   CHECK DTC AND FREEZE FRAME DATA*

   
   

   1. Check and record DTCs and Freeze Frame Data.

      Click here

      
      
      1. Chassis > DRS > Trouble Codes
      2. 
         
      3. 
         

   2. Clear the DTCs and Freeze Frame Data.

      Click here

      
      
      1. Chassis > DRS > Clear DTCs
      2. 
         
      3. 
         

   3. Recheck for DTCs.

      
      

      1. Simulate the malfunction and check if the DTCs are output again.

         Click here

         
         
         1. Chassis > DRS > Trouble Codes
         2. 
            
         3. 
            

      Result
      Result Proceed to DTCs are output. A DTCs are not output (Problem symptom does not occur) B DTCs are not output (Problem symptom occurs) C

   
   
   • AClick here
   • BClick here
   • CClick here

     GO TO STEP 7

5. Click here

   DIAGNOSTIC TROUBLE CODE CHART

   
   

   1. Proceed to Diagnostic Trouble Code Chart.

      Click here

      Result
      Proceed to NEXT

   
   
   • NEXTClick here

     GO TO STEP 8

6. Click here

   SYMPTOM SIMULATION

   
   

   1. Proceed to How to Proceed with Troubleshooting.

      Click here

      Result
      Proceed to NEXT

   
   
   • NEXTClick here
7. Click here

   PROBLEM SYMPTOMS TABLE

   
   

   1. Proceed to Problem Symptoms Table.

      Click here

      Result
      Proceed to NEXT

   
   
   • NEXTClick here
8. Click here

   CIRCUIT INSPECTION*

   Result
   Proceed to NEXT

   
   
   • NEXTClick here
9. Click here

   IDENTIFICATION OF PROBLEM

   Result
   Proceed to NEXT

   
   
   • NEXTClick here
10. Click here

    REPAIR OR REPLACEMENT

    Result
    Proceed to NEXT

    
    
    • NEXTClick here
11. Click here

    CONFIRMATION TEST*

    Result
    Proceed to NEXT

    
    
    • NEXT

      END