BRAKE CONTROL POWER SUPPLY INSTALLATION

CAUTION / NOTICE / HINT

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

PROCEDURE


  1. INSTALL BRAKE CONTROL POWER SUPPLY WITH BRACKET ASSEMBLY


    1. B004RHB

      Install the brake control power supply with bracket assembly to the vehicle body with the 2 nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    2. Connect the brake control power supply connector.

  2. INSTALL REAR LUGGAGE COMPARTMENT TRAY BRACKET RH

    Click here

  3. INSTALL SIDE TRIM BOX

    Click here

  4. INSTALL REAR FLOOR FINISH PLATE

    Click here

  5. INSTALL ROPE HOOK ASSEMBLY

    Click here

  6. INSTALL INNER LOWER LUGGAGE COMPARTMENT TRIM COVER

    Click here

  7. INSTALL TOOL BOX

    Click here

  8. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  9. INSTALL LUGGAGE COMPARTMENT TRIM COVER RH

    Click here

  10. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  11. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note

    Make sure that the 2 brake booster pump connectors are disconnected.

  12. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  13. CHECK AND CLEAR DTC

    Click here