STEERING ANGLE SENSOR REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during Steering sensor assembly removal/installation are shown below.
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Auxiliary battery terminal is disconnected/reconnected | Memorize steering angle neutral point | LKA/LDA system (for Mono camera type) | for Stereo Camera type: Click here for Mono Camera type: Click here |
| Lane control system (for Stereo camera type) | |||
| Parking support brake system* | |||
| Pre-collision system (for Stereo camera type) | |||
| Pre-collision system (for Mono camera type) | |||
| Adaptive high beam system | |||
Lighting system (EXT) |
|||
| Variable gear ratio steering system | |||
| Parking assist monitor system | |||
| Panoramic view monitor system | |||
| Initialize rear door sunshade system | Rear door sunshade system | ||
| Initialize power trunk lid system | Power trunk lid system | ||
| Steering sensor (Including removal and installation) | Steering angle neutral point | Parking support brake system | |
| Parking assist monitor system | |||
| Panoramic view monitor system | |||
| Steering angle setting | Parking assist monitor system | ||
| Panoramic view monitor system |
Click here Click here
CAUTION / NOTICE / HINT
Note
If both the spiral cable sub-assembly and the steering sensor are malfunctioning, replace them with a new spiral with sensor cable sub-assembly.
PROCEDURE
-
REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY
-
REMOVE STEERING SENSOR
-
Disengage the 6 claws and 2 pins, and remove the steering sensor from the spiral cable sub-assembly.
Note
Do not damage the claws and pins of the spiral cable sub-assembly.
-