Click here

REAR SPEED SENSOR INSTALLATION

Click here
Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

Note:

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

Click here

PROCEDURE


  1. Click here

    INSTALL REAR SPEED SENSOR LH


    1. B004REZ

      Install the rear speed sensor LH with the bolt.

      8.5 N*m 87 kgf*cm 75 in.*lbf
      Note:

      • The rear speed sensor is easily damaged. When installing the rear speed sensor to the rear axle hub LH, do not use excessive force to rotate and install it.

      • Prevent foreign matter from attaching to the sensor tip.

      • Do not drop the sensor. If the sensor has been dropped, replace the sensor with a new one.

  2. Click here

    INSTALL SKID CONTROL SENSOR WIRE


    1. B004XKS

      for LH Side:


      1. Install the sensor clamp with the bolt.

        8.5 N*m 87 kgf*cm 75 in.*lbf
        Note:

        Do not twist the skid control sensor wire.

      2. Connect the speed sensor connector to the rear speed sensor LH.

    2. B004U14

      for RH Side:


      1. Install the sensor clamp with the bolt.

        8.5 N*m 87 kgf*cm 75 in.*lbf
        Note:

        Do not twist the skid control sensor wire.

      2. Connect the speed sensor connector to the rear speed sensor RH.

      3. Connect the pad wear indicator connector.

    3. B004TQU

      Install the 3 sensor clamps with the 3 nuts.

      6.0 N*m 61 kgf*cm 53 in.*lbf
      Note:

      Do not twist the skid control sensor wire.

    4. Connect the rear height control sensor connector.

    5. Connect the absorber control actuator connector.

    6. B004WJX

      Insert the 2 skid control sensor wire connectors into the cabin from the hole in the rear wheel house.

    7. Attach the 2 grommets to the hole in the rear wheel house.

    8. B004R3W

      for LH Side:


      1. Connect the 2 cabin skid control sensor wire connectors.

    9. B004TZD

      for RH Side:


      1. Connect the 2 cabin skid control sensor wire connectors.

  3. Click here

    INSTALL LUGGAGE COMPARTMENT TRIM COVER INNER LH

    Click here

  4. Click here

    INSTALL LUGGAGE COMPARTMENT TRIM COVER INNER RH

    Click here

  5. Click here

    INSTALL REAR WHEEL

    Click here

  6. Click here

    CHECK FOR SPEED SENSOR SIGNAL

    Click here