Click here

TOE CONTROL LINK REMOVAL

Click here
Click here Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the toe control link removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Suspension, tires, etc.

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

 Parking support brake system

Click here

  • Parking assist ECU initialization

  • Adjust steering angle

  • Rear television camera view adjustment (for Rear camera detection system)

 Panoramic view monitor system

Click here
Rear television camera assembly optical axis (Back camera position setting) Parking assist monitor system

Click here

  • w/o Air Suspension System:

  • Replacement of the rear height control sensor sub-assembly LH, removal and reinstallation of the rear height control sensor sub-assembly LH, replacement of the suspension, etc. have been performed.

 Perform headlight ECU sub-assembly LH initialization Automatic headlight beam level control system

Click here
Note:

Be sure to read the "PRECAUTION" thoroughly before servicing.

Click here

Tip:

  • Use the same procedure for the RH and LH side.

  • The following procedure is for the LH side.

Click here

PROCEDURE


  1. Click here

    AIR SUSPENSION CONTROL PROHIBITED (w/ Air Suspension)

    Click here

  2. Click here

    REMOVE REAR WHEEL

    Click here

  3. Click here

    REMOVE NO. 2 DIFFERENTIAL SUPPORT PROTECTOR

    Click here

  4. Click here

    DISCONNECT SKID CONTROL SENSOR WIRE LH


    1. B004Y82

      Remove the bolt and disconnect skid control sensor wire LH from the toe control link sub-assembly LH.

  5. Click here

    REMOVE TOE CONTROL LINK SUB-ASSEMBLY LH


    1. B004SRZ

      Remove the nut.

    2. B004VMNC01
      *a SST (Spacer B) *b 1 mm (0.0394 in.)
      *c Spacer *d Center Nut
      *e Body *f Claw
      *g Parallel *h String

      Install 2 SST (spacer B) onto the toe control link sub-assembly LH so that there is a space of approximately 1 mm (0.0394 in.) between the arm and spacers.

      09960-20010 09961-02060
      Note:

      • Make sure to install the spacers (SST spacer B) as the rear axle carrier sub-assembly LH spacer may shift.

      • As SST may become damaged, make sure the space between the arm and spacers is not 1 mm (0.0394 in.) or less.

    3. Using SST, disconnect the toe control link sub-assembly LH from the rear axle carrier sub-assembly LH.

      09960-20010 09961-02010
      Note:

      • Apply molybdenum grease to the bolt threads and end of the SST bolt.

      • Do not damage the dust cover.

      • As the dust cover may be damaged, adjust SST with the center nut so that the body and claw are parallel.

      • Make sure to tie the string of SST to the vehicle to prevent SST from dropping.

    4. B004UTSC01
      *a Matchmark

      Place matchmarks on the rear suspension toe adjust cam sub-assembly, rear No. 2 suspension toe adjust plate and rear suspension member sub-assembly.

    5. Remove the nut, rear suspension toe adjust cam sub-assembly, rear No. 2 suspension toe adjust plate and toe control link sub-assembly LH.