LUGGAGE COMPARTMENT DOOR ADJUSTMENT

CAUTION / NOTICE / HINT

Tech Tips


  • B004UUAC01
    *a Centering Bolt
    *b Standard Bolt

    Centering bolts are used to mount the door hinge to the vehicle body and door. The door cannot be adjusted with the centering bolts on. Substitute the centering bolts for standard bolts when making adjustments.

  • A bolt without a torque specification is shown in the standard bolt chart.

    Click here

PROCEDURE


  1. INSPECT FITTING OF LUGGAGE COMPARTMENT DOOR PANEL SUB-ASSEMBLY


    1. Check that the clearance measurements of areas A to I are within the standard ranges.

      B004WH1N01
      Standard
      Area Measurement Area Measurement
      A -1.5 to 1.5 mm (-0.059 to 0.059 in.) B 2.7 to 5.7 mm (0.106 to 0.224 in.)
      C -1.5 to 1.5 mm (-0.059 to 0.059 in.) D 2.2 to 5.2 mm (0.087 to 0.205 in.)
      E -1.4 to 1.6 mm (-0.055 to 0.063 in.) F 2.9 to 5.9 mm (0.114 to 0.232 in.)
      G -1.9 to 2.1 mm (-0.075 to 0.083 in.) H 2.5 to 6.5 mm (0.098 to 0.256 in.)
      I 4.0 to 8.0 mm (0.157 to 0.315 in.) - -

  2. ADJUST LUGGAGE COMPARTMENT DOOR PANEL SUB-ASSEMBLY


    1. Remove the luggage compartment door hinge cover LH.

      Click here

      Tech Tips

      Use the same procedure for the RH and LH sides.

    2. B004X54

      Loosen the 4 hinge bolts on the body and adjust the door position.

    3. Tighten the 4 hinge bolts on the body after the adjustment.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
    4. B004TYJ

      Detach the claw and guide and remove the rear luggage room cover.

    5. B004VWI

      Using a T40 "TORX" socket, adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic hammer.

    6. Using a T40 "TORX" socket, tighten the striker mounting screws after the adjustment.

      Torque:
      23 N*m  { 235 kgf*cm, 17 ft.*lbf }

    7. Attach the claw and guide to install the rear luggage room cover.