CAUTION / NOTICE / HINT
-
*1 Centering Bolt *2 Standard Bolt Centering bolts are used to mount the hood hinge to the vehicle body and hood. The hood cannot be adjusted with the centering bolts on. Substitute the centering bolts for standard bolts when making adjustments.
-
A bolt without a torque specification is shown in the standard bolt chart.
-
Use the same procedure for RHD and LHD vehicles.
-
The procedure listed below is for LHD vehicles.
PROCEDURE
- Click here
INSPECT FITTING OF HOOD SUB-ASSEMBLY
-
Check that the all fitting dimensions are within the reference value ranges.
Standard Clearance Area Specified Condition Area Specified Condition A 1.85 to 5.85 mm (0.073 to 0.230 in.) B -0.65 to 3.35 mm (-0.026 to 0.132 in.) C 2.25 to 5.25 mm (0.089 to 0.207 in.) D -1.35 to 1.65 mm (-0.053 to 0.065 in.) E 2.15 to 5.15 mm (0.085 to 0.203 in.) F -0.45 to 2.55 mm (-0.018 to 0.100 in.) G 2.2 to 5.2 mm (0.087 to 0.205 in.) H -1.3 to 1.7 mm (-0.051 to 0.067 in.) I 2.5 to 5.5 mm (0.098 to 0.217 in.) J -1.4 to 1.6 mm (-0.055 to 0.063 in.)
-
- Click here
ADJUST HOOD SUB-ASSEMBLY
-
Adjustment in longitudinal direction of hood and horizontal direction of hood rear end.
-
Loosen the hood hinge assembly bolts and adjust.
13 N*m 133 kgf*cm 10 ft.*lbf Note:Replace the bolts with the supplied bolts before performing adjustment, as centering bolts are used.
-
-
Adjustment in vertical direction of hood front left and right ends.
-
Turn the cushion to adjust.
-
-
Remove the front bumper cover.
-
except Sport Package
-
for Sport Package
-
-
Remove the hood lock release lever protector.
-
Adjustment in vertical and horizontal directions of hood front end.
-
Loosen the 3 bolts and adjust.
8.0 N*m 82 kgf*cm 71 in.*lbf Note:Replace the bolts with the supplied bolts before performing adjustment, as centering bolts are used.
-
-
Install the hood lock release lever protector.
-
Install the front bumper cover.
-
except Sport Package
-
for Sport Package
-
-