Click here

POWER TRUNK LID SYSTEM, Diagnostic DTC:B2205

Click here
Click here
DTC Code DTC Name
B2205 Kick Sensor Circuit
Click here

DESCRIPTION

DTC B2205 is output when the luggage closer motor assembly detects that the kick door control sensor is stuck on.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory DTC Output from
B2205 Kick Sensor Circuit

One of the following conditions is met for approximately 60 seconds or more:


  • The luggage closer motor assembly detects a kick door control sensor short circuit

  • Luggage closer motor assembly malfunction

  • Kick door control sensor malfunction

  • kick door control sensor

  • Luggage closer motor assembly

  • Harness or connector

 ○ Luggage closer motor assembly
Table 1. *a KSOT *b KSIN *c Kick Door Control Sensor *d Luggage Closer Motor Assembly
Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

  • Before troubleshooting, make sure that the kick door control sensor is not damaged.

  • Before troubleshooting, be sure to read Precautions for Hands Free Power Trunk Lid.

    Click here

  • If the luggage closer motor assembly has been removed and installed or replaced, or if any of the connectors has been disconnected, initialize the power trunk lid system.

    Click here

  • After performing work, using the GTS, read the Data List item "Kick Sensor Connection" and check that the kick door control sensor is connected.

    Click here

  • Check the entry and start system (for Entry Function) first before troubleshooting the power trunk lid system.

    Click here

Click here

PROCEDURE


  1. Click here

    CHECK FOR DTC


    1. Clear the DTCs.

      Click here


      1. Body Electrical > Back Door > Clear DTCs


    2. Check for DTCs.

      Click here


      1. Body Electrical > Back Door > Trouble Codes


      OK
      DTC B2205 is not output.
      Result
      Proceed to
      OK
      NG

  2. Click here

    CHECK FOR DTC


    1. Disconnect the O5 kick door control sensor connector.

    2. Wait for approximately 60 seconds.

    3. Clear the DTCs.

      Click here


      1. Body Electrical > Back Door > Clear DTCs


    4. Check for DTCs.

      Click here


      1. Body Electrical > Back Door > Trouble Codes


      OK
      DTC B2205 is not output.
      Result
      Proceed to
      OK
      NG

  3. Click here

    CHECK HARNESS AND CONNECTOR (LUGGAGE CLOSER MOTOR ASSEMBLY - KICK DOOR CONTROL SENSOR)


    1. Disconnect the L10 luggage closer motor assembly connector.

    2. Disconnect the O5 kick door control sensor connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L10-24 (KSIN) or O5-3 (KSOT) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    • OK

      REPLACE LUGGAGE CLOSER MOTOR ASSEMBLYClick here

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR