Click here

POWER TRUNK LID SYSTEM, Diagnostic DTC:B2251

Click here
Click here
DTC Code DTC Name
B2251 PBD/PTL Closer Switch
Click here

DESCRIPTION

DTC B2251 is output if there is a malfunction in the half latch switch circuit of the luggage door closer assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory DTC Output from
B2251 PBD/PTL Closer Switch When luggage door is opening or closing, malfunction occurs in half-latch switch, striker switch circuit of luggage door closer assembly.

  • Luggage closer motor assembly

  • Harness or connector

  • Luggage door closer assembly

 ○ Luggage closer motor assembly
Table 1. *1 Half Latch Switch *2 Luggage Door Closer Assembly *3 Luggage Closer Motor Assembly
Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

  • If a luggage closer motor assembly DTC is output, the luggage compartment door closer and power trunk lid stops operating.

  • If the replacement, removal and installation of the luggage closer motor assembly or disconnection of the connectors of the luggage closer motor assembly has been performed, initialize the power trunk lid system.

    Click here

Click here

PROCEDURE


  1. Click here

    CHECK FOR DTC


    1. Clear the DTCs.

      Click here


      1. Body Electrical > Back Door > Clear DTCs


    2. Check for DTCs.

      Click here


      1. Body Electrical > Back Door > Trouble Codes


      OK
      DTC B2251 is not output.
      Result
      Proceed to
      OK
      NG

  2. Click here

    READ VALUE USING GTS


    1. Read the Data List according to the display on the GTS.

      Click here


      1. Body Electrical > Back Door > Data List
        Tester Display Measurement Item Range Normal Condition Diagnostic Note
        Half Latch SW Luggage closer motor assembly (half latch switch) signal OFF or ON

        ON: Luggage door closer assembly open-latched

        OFF: Luggage door closer assembly full-latched or half-latched

        		 -



      1. Body Electrical > Back Door > Data List
        Tester Display
        Half Latch SW




      OK
      The Data List display changes according to luggage compartment door operation.
      Result
      Proceed to
      OK
      NG

  3. Click here

    INSPECT LUGGAGE DOOR CLOSER ASSEMBLY


    1. B004URXC01
      *a

      Component without harness connected

      (Luggage Door Closer Assembly)

      		 *b Open
      *c Half latch - -

      Remove the luggage door closer assembly.

      Click here

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      6 (FSW) -7 (E) Open Below 1 Ω
      Half latch 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

  4. Click here

    CHECK HARNESS AND CONNECTOR (LUGGAGE CLOSER MOTOR ASSEMBLY - LUGGAGE DOOR CLOSER ASSEMBLY)


    1. Disconnect the L10 luggage closer motor assembly connector.

    2. Disconnect the L12 luggage door closer assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L10-7 (HAF) - L12-6 (FSW) Always Below 1 Ω
      L10-7 (HAF) or L12-6 (FSW) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    • OK

      REPLACE LUGGAGE CLOSER MOTOR ASSEMBLYClick here

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR