SLIDING ROOF HOUSING REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during sliding roof glass sub-assembly, sliding roof housing sub-assembly, sliding roof drive gear assembly or sliding roof drive cable sub-assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point LKA/LDA system (for Mono camera type)

for Mono Camera type: Click here

for Stereo Camera type: Click here

Lane control system (for Stereo camera type)
Parking support brake system*
Pre-collision system (for Stereo camera type)
Pre-collision system (for Mono camera type)
Adaptive high beam system

    Lighting system (EXT)

  • Cornering lights
Variable gear ratio steering system

Click here

Parking assist monitor system

Click here

Panoramic view monitor system

Click here

Initialize rear door sunshade system Rear door sunshade system

Click here

Initialize power trunk lid system Power trunk lid system

Click here


  • Roof glass (Including removal and installation)

  • Sliding roof drive gear sub-assembly

 Initialize sliding roof system

  • Auto function

  • Jam protection function

  • Key-off operation

  • Wireless transmitter-linked operation

  • Key-linked function

  • Open warning function may not operate

  • Sliding roof may become misaligned

Click here

*: When performing learning using the GTS.
Click here

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read precaution thoroughly before servicing.

    Click here

    B004U54

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE SLIDING ROOF SIDE GARNISH LH


    1. B004T47

      Remove the sliding roof side garnish LH from the rail.

  3. REMOVE SLIDING ROOF SIDE GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  4. REMOVE SLIDING ROOF SIDE GARNISH LH


    1. B004RIT

      Detach the claw to remove the sliding roof side garnish LH.

  5. REMOVE SLIDING ROOF SIDE GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  6. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY


    1. Move the sliding roof glass sub-assembly to the fully closed position.

    2. Using a T25 "TORX" socket wrench, remove the 4 "TORX" screws and sliding roof glass sub-assembly.

      B004TUO

      Note

      When removing the sliding roof glass sub-assembly, move the sliding roof glass sub-assembly to the fully closed position.

  7. REMOVE SLIDING ROOF WEATHERSTRIP


    1. B004TIV

      Remove the sliding roof weatherstrip from the sliding roof panel sub-assembly.

  8. REMOVE CURTAIN SHIELD AIR BAG ASSEMBLY RH

    Click here

  9. REMOVE CURTAIN SHIELD AIR BAG ASSEMBLY LH

    Tech Tips

    Use the same procedure as for the RH side.

  10. REMOVE SLIDING ROOF HOUSING SUB-ASSEMBLY


    1. B004R44

      Remove the clip.

      Tech Tips

      Use the same procedure for the other 3 clips.

    2. Disconnect the 4 sliding roof drain hoses.

    3. Remove the 8 bolts, 8 nuts and sliding roof housing sub-assembly.

      B004XQF

      Note

      If the removed nut is the same shape as that shown in the illustration, replace it the supplied replacement part.

      B004VS8