VOLTAGE INVERTER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the luggage compartment door removal/installation are shown below.

PROCEDURE

1. Click here

   REMOVE LUGGAGE COMPARTMENT FLOOR MAT

   Click here

2. Click here

   REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

   Click here

3. Click here

   REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

   Click here

4. Click here

   REMOVE LUGGAGE COMPARTMENT TRIM COVER RH

   Click here

5. Click here

   REMOVE TOOL BOX

   Click here

6. Click here

   REMOVE INNER LOWER LUGGAGE COMPARTMENT TRIM COVER

   Click here

7. Click here

   REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (w/o Rear Air Conditioning System)

   Click here

8. Click here

   REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (w/ Rear Air Conditioning System)

   Click here

9. Click here

   REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

   Click here

10. Click here

    REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER

    Click here

11. Click here

    REMOVE ROPE HOOK ASSEMBLY

    Click here

12. Click here

    REMOVE REAR FLOOR FINISH PLATE

    Click here

13. Click here

    REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH

    Tip:

    Use the same procedure described for the RH side.

    Click here

14. Click here

    REMOVE REAR LUGGAGE COMPARTMENT TRAY BRACKET LH

    Tip:

    Use the same procedure described for the RH side.

    Click here

15. Click here

    REMOVE VOLTAGE INVERTER ASSEMBLY

    
    
    1. 

       	Nut
       	Connector

       Disconnect the connector.

    2. Remove the 2 nuts and remove the voltage inverter assembly.

       

       Note:

       If the removed nut is the same shape as that shown in the illustration, replace it the supplied replacement part.