ION GENERATOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL ION GENERATOR SUB-ASSEMBLY


    1. B004SS3C01
      *a Guide
      *b Claw
      B004RMI Align with the guide position and insert in a straight line

      Align the guide, attach the claw and install the air duct sub-assembly to the ion generator sub-assembly as shown in the illustration.

    2. B004W71C01
      B004SZX Screw
      B004UK4 Air duct
      B004RMI Insert in this Direction

      for LHD:


      1. Insert the ion generator sub-assembly with air duct sub-assembly in the direction of the arrow shown in the illustration, and then insert the air duct sub-assembly into the No. 3 heater to register duct sub-assembly as shown in the illustration.

      2. Set the guide into place and install the ion generator sub-assembly with air duct sub-assembly with the 2 screws.

    3. B004U26C02
      B004SZX Screw
      B004UK4 Air duct
      B004RMI Insert in this Direction

      for RHD:


      1. Insert the ion generator sub-assembly with air duct sub-assembly in the direction of the arrow shown in the illustration, and then insert the air duct sub-assembly into the No. 3 heater to register duct sub-assembly as shown in the illustration.

      2. Set the guide into place and install the ion generator sub-assembly with air duct sub-assembly with the 2 screws.

  2. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  5. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  6. INSPECT SRS WARNING LIGHT

    Click here