Click here

LUGGAGE CLOSER ECU REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the luggage closer motor assembly removal/installation are shown below.

Replacement Part Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
The luggage closer motor assembly Reset connection history There are cases where the connection history display differs from the vehicle condition

Click here
Initialize luggage closer motor assembly The power trunk lid does not operate

Click here

  • The luggage closer motor assembly connector is disconnected

  • When the luggage compartment door is opened using a mechanical key

 Initialize luggage closer motor assembly The power trunk lid does not operate

Click here
Click here

PROCEDURE


  1. Click here

    REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  2. Click here

    REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  3. Click here

    REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  4. Click here

    REMOVE LUGGAGE COMPARTMENT TRIM COVER RH

    Click here

  5. Click here

    REMOVE TOOL BOX

    Click here

  6. Click here

    REMOVE INNER LOWER LUGGAGE COMPARTMENT TRIM COVER

    Click here

  7. Click here

    REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (w/o Rear Air Conditioning System)

    Click here

  8. Click here

    REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (w/ Rear Air Conditioning System)

    Tip:

    Use the same procedure described for the front luggage compartment trim cover (w/o Rear Air Conditioning System).

  9. Click here

    REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

    Click here

  10. Click here

    REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER

    Click here

  11. Click here

    REMOVE ROPE HOOK ASSEMBLY

    Click here

  12. Click here

    REMOVE REAR FLOOR FINISH PLATE

    Click here

  13. Click here

    REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH


    1. B004SDHC03
      B004RMI Remove in this Direction
      B004UK4 Push

      Push the lever in the direction of the arrow shown in the illustration and remove the rope hook.

    2. B004UPGC03
      B004RMI Remove in this Direction
      B004SZX Clip
      B004UK4 Grommet

      Remove the grommet.

    3. Using a clip remover, detach the 2 clips and remove the luggage compartment trim cover assembly LH.

  14. Click here

    REMOVE LUGGAGE CLOSER MOTOR ASSEMBLY


    1. B004UUHC05
      B004SZX Bolt
      B004UK4 Nut
      B004XCB Connector

      Disconnect the connector.

    2. Remove the nut and 3 bolts.

    3. B004RV9C03
      B004RMI Remove in this Direction

      Detach the guide and remove the luggage closer motor assembly in the direction indicated by the arrow shown in the illustration.

      Note:

      • While holding the luggage closer motor assembly, remove it.

      • Do not drop the luggage closer motor assembly.