Click here

FUEL VAPOR CONTAINMENT VALVE(w/ Canister Pump Module) REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel vapor containment valve (fuel tank solenoid main valve assembly) removal/installation are shown below.

Table 1. Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point LKA/LDA system (for Mono camera type)
Lane control system (for Stereo camera type)
Parking support brake system*
Pre-collision system (for Stereo camera type)
Pre-collision system (for Mono camera type)
Adaptive high beam system

  • Lighting system (EXT)

  • Cornering lights
Variable gear ratio steering system

Click here
Parking assist monitor system

Click here
Panoramic view monitor system

Click here
Initialize rear door sunshade system Rear door sunshade system

Click here
Initialize power trunk lid system Power trunk lid system

Click here
*: When performing learning using the GTS. Click hereClick here
Note:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click here

Click here

PROCEDURE


  1. Click here

    REMOVE FUEL TANK CAP ASSEMBLY


    1. B004RFP

      Press the lid opener switch to release the pressure in the fuel tank assembly.

    2. Remove the fuel tank cap assembly.

  2. Click here

    REMOVE REAR SUSPENSION MEMBER WITH DIFFERENTIAL CARRIER

    Click here

  3. Click here

    DISCONNECT FUEL TANK VENT HOSE SUB-ASSEMBLY


    1. Disconnect the 2 fuel tank vent hose sub-assemblies from the fuel tank solenoid valve with hose assembly.


      1. B004WE5C01
        *a Retainer
        B004SZX Pinch
        B004UK4 Up

        Pinch the retainer and raise it.

        Note:

        • Do not use any tools in this procedure.

        • Check for any dirt and foreign matter contamination in the fuel tank solenoid valve with hose assembly and around the connector. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the fuel tank solenoid valve with hose assembly and connector.

        Tip:

        Do not remove the retainer.

      2. Disconnect the fuel tank vent hose sub-assembly from the fuel tank solenoid valve with hose assembly.

  4. Click here

    REMOVE FUEL TANK SOLENOID VALVE WITH HOSE ASSEMBLY


    1. B004VFF

      Detach the clamp and disconnect the connector from the fuel tank solenoid valve with hose assembly.

    2. B004Y0G

      Remove the 2 nuts and fuel tank solenoid valve with hose assembly from the body.

  5. Click here

    REMOVE FUEL TANK SOLENOID MAIN VALVE ASSEMBLY


    1. B004XPG

      Remove the 2 nuts and fuel tank solenoid main valve assembly from the charcoal canister bracket sub-assembly.