Click here

FUEL SENDER GAUGE ASSEMBLY REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel sender gauge assembly removal/installation are shown below.

Table 1. Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point LKA/LDA system (for Mono camera type)
Lane control system (for Stereo camera type)
Parking support brake system*
Pre-collision system (for Mono camera type)
Pre-collision system (for Stereo camera type)
Adaptive high beam system

  • Lighting system (EXT)

  • Cornering lights
Variable gear ratio steering system

Click here
Parking assist monitor system

Click here
Panoramic view monitor system

Click here
Initialize rear door sunshade system Rear door sunshade system

Click here
Initialize power trunk lid system Power trunk lid system

Click here
*: When performing learning using the GTS. Click hereClick here
CAUTION:

  • B004WLP

    Never perform work on fuel system components near any possible ignition sources.

  • Vaporized fuel could ignite, resulting in a serious accident.


  • B004U4I

    Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.

  • Sparks could cause vaporized fuel to ignite, resulting in a serious accident.

Click here

PROCEDURE


  1. Click here

    DISCHARGE FUEL SYSTEM PRESSURE

    Click here

  2. Click here

    PRECAUTION

    Note:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work.

    Click here

  3. Click here

    DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. Click here

    REMOVE REAR SEAT CUSHION ASSEMBLY


  5. Click here

    REMOVE NO. 1 REAR FLOOR SERVICE HOLE COVER


    1. B004VEO

      Remove the No. 1 rear floor service hole cover.

    2. Disconnect the No. 2 fuel sender gauge assembly connector.

  6. Click here

    REMOVE NO. 2 FUEL SENDER GAUGE ASSEMBLY


    1. B004XCU

      Remove the 5 screws and No. 2 fuel sender gauge assembly.

  7. Click here

    REMOVE NO. 2 REAR FLOOR SERVICE HOLE COVER

    Click here

  8. Click here

    DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

    Click here

  9. Click here

    REMOVE FUEL TANK VENT TUBE SET PLATE

    Click here

  10. Click here

    REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

    Click here

  11. Click here

    REMOVE FUEL SENDER GAUGE ASSEMBLY


    1. B004S98

      Disconnect the fuel sender gauge assembly connector.

    2. Detach the claw and slide the fuel sender gauge assembly upward to remove it.